
Cleaning wiper manufacturers take you to understand the correct way to use the wiper
- Categories:cleaning wiper
- Author:
- Origin:
- Time of issue:2022-08-23
- Views:
(Summary description)1. The rag partition. The cleaning wiper manufacturer tells you that the rags at home are best divided according to areas, such as kitchen, bathroom, living room, bedroom, etc. Among them, the rags for cleaning and wiping tableware in the kitchen must be separated from those for wiping the countertops. Specifically, the rag should be soft, clean, not too hard, and should not feel sticky and wet, especially should not show obvious dirty marks.
Cleaning wiper manufacturers take you to understand the correct way to use the wiper
(Summary description)1. The rag partition. The cleaning wiper manufacturer tells you that the rags at home are best divided according to areas, such as kitchen, bathroom, living room, bedroom, etc. Among them, the rags for cleaning and wiping tableware in the kitchen must be separated from those for wiping the countertops. Specifically, the rag should be soft, clean, not too hard, and should not feel sticky and wet, especially should not show obvious dirty marks.
- Categories:cleaning wiper
- Author:
- Origin:
- Time of issue:2022-08-23
- Views:
1. The rag partition. The cleaning wiper manufacturer tells you that the rags at home are best divided according to areas, such as kitchen, bathroom, living room, bedroom, etc. Among them, the rags for cleaning and wiping tableware in the kitchen must be separated from those for wiping the countertops. Specifically, the rag should be soft, clean, not too hard, and should not feel sticky and wet, especially should not show obvious dirty marks.
2. Replacement cycle. The cleaning wiper manufacturer tells you that it is recommended that people decide whether to replace the wiper according to the cleanliness of the wiper and try to change it every two or three months. The rags that frequently come into contact with tableware and so on need to be replaced in about a week, and they should be boiled in boiling water with a little alkali for no less than 5 minutes.
3. Clean the rag. The cleaning wiper manufacturer tells you that bacteria like a humid environment. Do not place the wiper on the side of the pool or on the operating table after use, otherwise, it will "cultivate" more bacteria. After each use, it should be thoroughly washed with detergent. Be careful not to wash it in a lump when washing. It is best to wash it in sections and sections, rinse it thoroughly, and finally dry it with natural ventilation. When sterilizing the rag, it can be boiled in boiling water or steamed in a pressure cooker for 10 to 15 minutes, which can kill general bacteria.
The above is the cleaning wiper manufacturer's introduction and analysis of the correct way to use the wiper, hope it helps you.

The manufacturing process of oil absorbent pads

Introduction of classification of oil absorbent pads

Features of Melt-blown fabric

Application field of Melt-blown fabric
ADD:No.399 West Section Of Fucheng Avenue,Hi-Tech Zone,ChengDu,China

Key words:
Filter Material Adsorption Products Filter Adsorption Medical Accessories Medical Liquid Absorbent Pad Oil Absorbent Cotton Oil Absorbent Cord Graphene Respirator Mask Material PM2.5
©2021 Sichuan Juneng Filter Material Co.,ltd Copyright Powered by www.300.cn